I am design a part assembly conveyor. The conveyor will be running off 208VAC, 3 PHASE, 4 WIRE. The total length of the conveyor is about 90 feet long. The conveyor will have to split it in half (due to shipping and installation purposes). Thus, the power line will have to be broken, and I do not want to roll back the power line. So! my question is this, per code (NEC) in breaking the power line, is there anything I can use to break the line and retach it(by the way there is wireway on this system).
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Power Line for conveyor
- Thread starter bigdog
- Start date
- Status
Similar threads
- Question
- Question
- Question
- Locked
- Question