Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Power copy

Status
Not open for further replies.
CATPart

CATPart

Automotive
Joined
Jun 12, 2006
Messages
115
Location
NO
1. Please for suggestion on how to make a power copy in V5R16 SP5 without gaps (see image).
When instantiated I want to be asked to select only the FACE and POINT.
I have made it using three holes (simple, countersunk, threaded) but I was forced to put small gaps (0.01 mm).

2. Above mentioned PowerCopy can be instantiated when I select the face of pad,
but I receive error when I select the face which is the result of some boolean operation.
What could be the problem?

94686787bd9.jpg
 
Sort by date Sort by votes
Can you email the aforementioned Part.
nevjohnson@yahoo.co.uk

I'll take a look at it 4 U

Regards

Nev
 
Upvote 0 Downvote
nev99,

It's on the way.

Rgds,
Damir
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Y
  • Locked
  • Question Question
About copy - paste special - copy with link in product
Replies
3
Views
2K
yamaCad
Y
R
Copy part from educative licence
Replies
1
Views
1K
MrCATIA
M
Y
  • Locked
  • Question Question
Copy bodies from selected part bodies in product
Replies
4
Views
3K
yamaCad
Y
reutov_tv
  • Locked
  • Question Question
Copy-paste with link --> Thread not detected on drawing
Replies
0
Views
298
reutov_tv
reutov_tv
Ardilla07
  • Locked
  • Question Question
CATIA Copy & Paste Error
Replies
0
Views
631
Ardilla07
Ardilla07

Part and Inventory Search

Sponsor

Back
Top