How do you calculate if a P.T. is suitable for a meter? I have a three phase P.T. (open delta- 4200:120V) that is 0.3WX, 0.6M, 1.2Y AND 500VA thermal rating @ 30 Degree C. The meter I am connecting it to has a 5M ohm input impedance. I want to connect 5 meters to the same P.T. Any advice guys?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Potential Transfomer Selection 3
- Thread starter mmt019
- Start date
jbartos
Electrical
- Jan 15, 2000
- 6,440
Suggestion: It may be a good idea to follow the CT and PT transformers manufacturer recommendations, since the industry standards tend to be so so at their limits. E.g. some PT manufacturers deviate from industry standards rated secondary voltage.
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question
- Locked
- Question