Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Post Processor Question

Thread starter BrianM4x4
Start date Feb 29, 2004

Status: Not open for further replies.

Feb 29, 2004

BrianM4x4

Mechanical

Hi Guys

We are designing and programming with UGNX2 at work, I was messing around with the mill3ax post to try and tweak the output a little. I did everthing I wanted to except, I cannot figure out how to get it to output the program name in brackets. Currently it just starts right in with the first line number.

Thanks for your help