Post Processor for Milltronics tool room Mill (3 axis)

[skennedy]

I'm trying to locate a post processor for a Milltronics tool room mill that uses a centurion 6 controller. The last three quotes from PTC sources have been too high (in excess of 3000 dollars) for a working post.



Any suggestions much appreciated

 

[ctarmijo]

Dear skennedy,

What software are you using? Is it G-Post or is it NC-Post?



ctarmijo

 

[skennedy]

NC-Post

 

[rtrezise]

I have a post for that machine

send me an e-mail so i can send it to you.

rtrezise@edlon.com