Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Post Processing

Status
Not open for further replies.

creves

Automotive
Joined
Nov 29, 2004
Messages
1
Location
US
Hi All,

Because UG's Post processer is so incredibly
complicated without the "post builder".
Are there any sites out there
that have post's you can download for certain mills, or
perhaps a company that will make a custom post for you.


Thanks in advance,

Curtis
 
The post builder is the same as any other genric post processor customization program.

You must have some means of customizing a post for your machines.


"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
 
I am writing posts mainly for milling machines. So far I have written posts for heidenhain, Philips, mazatrol, siemens okuma and fanuc controllers. I have a wire edm post as well for agie vision.

At the moment I am writing posts directly for ugs as a contracter.

The most advanced I have done is an isv post for a mori-seiki nh4000dcg.

 
If you contact me personally, I can help you with your post processor needs. You can find my contact information when you go to my web site, listed below.

-Derek
DL Engineering Services

specializing in CAD Design Consultation Services
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top