Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Point Load input in ABAQUS

Status
Not open for further replies.

Shindey

Geotechnical
Joined
Dec 29, 2010
Messages
39
Location
AE
There are 6 points to be loaded with load sixtet(FX,FY,FZ,MX,MY,MZ).

I have been provided the loads in tabular formats.

If I want to input the load in ABAQUS, I have to create 12 loads.
6 point x 2 loads for each point( one for inputting the concentrated force, and the other one for inputting concentrated moment.)

This way of inputting is too cumbersome and error prone.

Is there any simpler way of inputting the load data to ABAQUS?

Rgds
Shailesh
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top