beachcomber
Mechanical
Has anyone any experience of getting point cloud data into SE and creating surfaces ?
bc
bc
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Point Cloud Data
- Thread starter beachcomber
- Start date
- Status
It does not like. I think V20 may open up STL data but I don't know what it will do with it.
At one point UGS was giving out a macro that would bring in every point one at a time. It was slow and a bad idea for files with lots of points.
If you really want to do a good job of reverse engineering the truth is you will need a package that is designed for it like Imageware or raindrop or paraform.
At one point UGS was giving out a macro that would bring in every point one at a time. It was slow and a bad idea for files with lots of points.
If you really want to do a good job of reverse engineering the truth is you will need a package that is designed for it like Imageware or raindrop or paraform.
- Status