Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pneumatic seal design

Status
Not open for further replies.
Sa-Ro

Sa-Ro

Mechanical
Jul 15, 2019
279
Hi

It is regarding pneumatic seal design.

IMG_20200909_101737_f8l85e.jpg


How will be the break loose force in single point and double point contact?

Assume equal squeeze in both design.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
In your drawing there is no difference between the two designs at the sliding contact.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

smyluk
  • Locked
  • Question
Flocked Coating on Sliding Rubber Seal
Replies
3
Views
605
btrueblood
btrueblood
Garrett Green
  • Locked
  • Question
Shore A Hardness for sealing 1
Replies
9
Views
524
Tmoose
Tmoose
TugboatEng
  • Locked
  • Question
Lip Seal Damage 1
Replies
5
Views
474
acspain
acspain
tomecki
  • Locked
  • Question
Inflatable Rubber Seal Design References 1
Replies
2
Views
182
GrahamBennett
GrahamBennett
dru5237
  • Locked
  • Question
Rubber Extruder Design Resources
Replies
1
Views
194
GrahamBennett
GrahamBennett

Part and Inventory Search

Sponsor

Back
Top Bottom