NutAce
Mechanical
- Apr 22, 2010
- 1,192
Hello All,
I ran into a interesting issue with PMI...
In an assembly I have 2 cylindrical bushes at a certain distance. With PMI I place a horizontal dimension to the outside of those bushes (tangential) in the Iso metric view.
Now when I create a view on the drawing (mastermodel) the dimension shifts (on one bush) from the tangential outside to the Tangential Inside (shortest distance between bushes).
The Value of the Dimension stays the same however...
Anyone else ever had this issue?
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5
HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5
I ran into a interesting issue with PMI...
In an assembly I have 2 cylindrical bushes at a certain distance. With PMI I place a horizontal dimension to the outside of those bushes (tangential) in the Iso metric view.
Now when I create a view on the drawing (mastermodel) the dimension shifts (on one bush) from the tangential outside to the Tangential Inside (shortest distance between bushes).
The Value of the Dimension stays the same however...
Anyone else ever had this issue?
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5
HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5
