I am using CII Ver. 5.1. Is there a way to scale a plot from the input so that the display on the screen will cover the entire page of the print out? When I try to print the plot that is displayed on the screen, I will get a plot that is shrunk to the center of the page.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Plotting
- Thread starter stressfan
- Start date
- Thread starter
- #3
For some reason "landscape mode" doesn't take the full width of the page. This is a problem in the "graphics library" that CAESAR II uses. We'll go back to the vendor and get this resolved.
Printing in "portrait mode" should take the full page.
Richard Ay
COADE, Inc.
Printing in "portrait mode" should take the full page.
Richard Ay
COADE, Inc.
- Thread starter
- #5
- Status