DrDarwich
Bioengineer
- Feb 15, 2013
- 3
Hi all,
I am using Mimics to segment maxillofacial CT images and generate the 3D model of the mandible and export it to Femap in STL extension to perform stress analysis. However, it seems that Femap sees the model as a plot planar mesh, meaning that the mesh is failed within FE solver because some of parasite internal structures. Are there any ideas or softwares to repair or overcome this problem.
Please take a look at the appeared problem on the image uploaded at this address:
Your answer and cooperation are highly appreciated.
Dr. Darwich
I am using Mimics to segment maxillofacial CT images and generate the 3D model of the mandible and export it to Femap in STL extension to perform stress analysis. However, it seems that Femap sees the model as a plot planar mesh, meaning that the mesh is failed within FE solver because some of parasite internal structures. Are there any ideas or softwares to repair or overcome this problem.
Please take a look at the appeared problem on the image uploaded at this address:
Your answer and cooperation are highly appreciated.
Dr. Darwich