Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Please ,I need your info

Status
Not open for further replies.
jomblo

jomblo

Mechanical
Feb 9, 2008
1
Dear,Please give me advise about my engine.I have diesel engine type ESL MK 2 made by Mirrless Blackstone.I do not know about how much temperatur injector tip cooling acceptable level ?( position inlet and outlet injector ).
Note:injector tip cooling by HSD ( high speed diesel ).
Thank's for all attention

 
Replies continue below

Recommended for you

Sort by date Sort by votes
Why don't you ask the manufacturer?

TTFN

FAQ731-376
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

341968
  • Question
HIGH VOLTAGE EQUIPMENT DISCHARGE IN HAZARDOUS AREA ZONE 2.
Replies
0
Views
2K
341968
341968
moobe
  • Locked
  • Question
Please suggest a good Anemometer
Replies
3
Views
496
Lou Scannon
Lou Scannon
Banji Isioye
  • Locked
  • Question
Caterpillar PMG3516C (XQ1475G) starts and Stalls Immediately 2
2
Replies
24
Views
2K
TugboatEng
TugboatEng
Saver2008
  • Locked
  • Question
How much natural gas for burning ACID GAS in a thermal oxidizer
Replies
2
Views
679
Compositepro
Compositepro
RodRico
  • Locked
  • Question
I'm running CFD of a micro-fuel inj
Replies
0
Views
376
RodRico
RodRico

Part and Inventory Search

Sponsor

Back
Top Bottom