Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plate Heat Exchangers

Status
Not open for further replies.
Sharik

Sharik

Mechanical
Joined
Sep 17, 2003
Messages
135
Location
CA
For replacement plates for Plate Heat Exchangers, what are the required documentation? Is a Partial Data Report required or are just Mill Test Reports traceable to the plates sufficient?
 
Sort by date Sort by votes
Are you referring to "Repair" as per NBIC, Part 3?
 
Upvote 0 Downvote
The scope of repair/alterations would be the replacement of plates or the installation of additional plates.
 
Upvote 0 Downvote
It sounds like a "Repair" as per NBIC, Part 3 for me.
See NBIC, Part 3, 3.3.
 
Upvote 0 Downvote
Would Partial Data Reports be required for the new plate exchanger plates?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Inchtain
  • Locked
  • Question Question
Safety Valves for Pressure Vessels and Heat Exchangers
Replies
12
Views
5K
r6155
r6155
EngTal
  • Locked
  • Question Question
Metal jacketed vs Spiral wound gaskets for Heat Exchangers
Replies
6
Views
4K
ShabsRBI
ShabsRBI
MchA
  • Question Question
TEMA DEU/CEU Heat Exchanger - Connection Challenges & Analysis
Replies
18
Views
21K
r6155
r6155
Whin
  • Question Question
Heat Exchanger one stream out of service
Replies
3
Views
569
LittleInch
LittleInch
BasakAbhishek
  • Question Question
Typical cylindricity of shells made by plate rolling
Replies
4
Views
2K
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top