Piping wall thickness calculation during hydrotest condition

[Sean_Wei]

Hi，Forums

Piping wall thickness calculation according ASME B31.3 is using the design pressure of pipeline，while the hydrotest pressure is at least 1.5×design pressure.

The question is why B31.3 doesn't require to do the calculation check under hydrostatic test pressure？

 

[Trestala]

The purpose of hydrostatic test is to verify the strength of your piping if it can handle the design pressure safely by using a pressure above it.

 

[goutam_freelance]

Refer the thread
https://www.eng-tips.com/threads/hydrotest-clarification.528306/

 

[GD2]

Hi，Forums

Piping wall thickness calculation according ASME B31.3 is using the design pressure of pipeline，while the hydrotest pressure is at least 1.5×design pressure.

The question is why B31.3 doesn't require to do the calculation check under hydrostatic test pressure？

It is all about stress. You need to convert the test pressure to stress. Use Barlow's equation. Make sure that stress does not exceed YS. Typically, companies keep it limited to 0.9YS at test temperature.
It's a bit of mind puzzling in the beginning. You need to learn the relationship between pressure and stress - tow different parameters but inter-related.