Piping Iso diagrams 2

[grunt58]

Piping Iso diagrams are from the center of the pipe, correct? See attached sample.

 

[grunt58]

Yes, it does stab in and cross center line.
Customer admitted to reading the ISO drawing wrong. They approved our drawing.

 

[saplanti]

It still seems to be funny application to me. In case they introduce additional liquid to the main and want it mixed with flow it may be the case. But the main liquid flow will introduce forces to the stub-in pipe. Perhaps the engineer considered all the effects on the connection of the main wall.

 

[oilandgasfundas]

Hello Friends,

Created a platform for all the Piping Engineering guys, more than 45 Videos have already been covered.
Look at the video links, lets make this platform more useful with your presence and utilize it as a discussion forum. Check out at :

https://bit.ly/Oilandgasfundas

01. Introductory Video (3.5 minutes)
02. Introduction to Piping (Total 40 Minutes)
03. Design Basis (Total 30 Minutes)
04. Process Interface with Piping (15 Minutes)
05. Pipe Rack (Total 25 minutes only)
06. Column Piping : (Total 1 hour 20 Minutes)
07. Pump Piping (total 55 minutes only)
08. Compressor Piping and layout (total 1 hour 20 minutes)
09. Overall Plot plan : (15 minutes only)
10. Unit Plot plan (Total 55 minutes only)
11. Valve Operation & accessibility (Total 18 Minutes)

Regards