PICKADD PROBLEM!

[11echo]

I've run across this variable in the new cad program. I understand how to change it, BUT on occasions this variable changes itself! ...This can be VERY annoying!!! Anybody know where to set the variable so it won't change by itself? THX! ...Mark

 

[tools4u]

you can set it from the command line or
options > selection > selection mode > check box "use shift to add"
but I am not sure why it would change, not sure if a profile change would cause it to happen.

 

[JPARKER70]

A PROGILE CHANGE COULD CAHINGE IT ALONG WITH LOADING ADD ON PROGRAMS MIGHT ALSO CHANGE IT.