Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Photoworks in SolidWorks2007x64

Thread starter dogarila
Start date Feb 1, 2007

Status: Not open for further replies.

Feb 1, 2007

dogarila

Mechanical

I would like to know if anyone was able to complete the PhotWorks tutorials in SW07x64. I did them last week in SW07x32. Now, in SW07x64, I am unable to set the scene as required by the tutorial. The Scene Editor dialog box disapears after selecting the material for the floor. When I click on the Scene Editor again, to bring back the dialog window, it reverts to the initial values.