G
Geoff T
Guest
Does anyone know if Wildfire 3 can create pdf's using "ScansoftPDF Create 4.0" instead of Adobe? Or indeed any other PDF software?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Status
- Thread starter
- #2
I
Israr
Guest
Wildfire 3 can create pdf's without any software. In drawing mode just click on SAVE AS and select pdf.
Enjoy
Enjoy
- Thread starter
- #3
C
conrat
Guest
Israr,
Do you know if there are any ways to set default settings in the PDF
creation tool in Pro/E. I would like it to default to monochrome,
but at this point, I have found no way of setting this as a default.
Thanks,
Jim
Do you know if there are any ways to set default settings in the PDF
creation tool in Pro/E. I would like it to default to monochrome,
but at this point, I have found no way of setting this as a default.
Thanks,
Jim
- Thread starter
- #4
I
Israr
Guest
There is a hidden config.pro option which does what you want. At this time, I am not at home. I will let you know later.
Israr
Israr
- Thread starter
- #5
C
conrat
Guest
Great! I appreciate your response.
Jim
Jim
- Thread starter
- #6
M
michael3130
Guest
Geoff and Conrat,
Be caredul using ProE to create PDFs. We have had serious issues with it making up lines and leaving out lines and just generally screwing things up.
It was so bad all ProE users have had Acrobat installed to output drawings as PDFs so we know it will be done correctly
Michael
Be caredul using ProE to create PDFs. We have had serious issues with it making up lines and leaving out lines and just generally screwing things up.
Michael
- Thread starter
- #7
E
Evil Flo
Guest
I personally use PDFCreator. I print using Generic Postscript, having PDFCreator as my default printer and it does a wonderful job. Line thickness and font appear exactly how I want them to appear.
- Thread starter
- #8
C
conrat
Guest
Though I do not know exactly how it works, you can use Ghostscript to
print PDF files as well. It seemed a bit complicated, but I
believe there are instructions on MCAD central.
Try searching for GHOSTSCRIPT.
I like the new button in WF3 myself.
Jim
print PDF files as well. It seemed a bit complicated, but I
believe there are instructions on MCAD central.
Try searching for GHOSTSCRIPT.
I like the new button in WF3 myself.
Jim
- Thread starter
- #9
M
magnusod
Guest
michael3130 said:Geoff and Conrat,
Be caredul using ProE to create PDFs. We have had serious issues with it making up lines and leaving out lines and just generally screwing things up.It was so bad all ProE users have had Acrobat installed to output drawings as PDFs so we know it will be done correctly
Michael
We also had a few strange behaviours in the beginning but after checking box "Visible only" under Layers in Content tab all our problems disappeared.
- Thread starter
- #10
G
Geoff T
Guest
Thanx for all the response guys, You've all been great and as a new pro-e user, this forum has so far proven very helpfull!
- Status
Similar threads
- Locked
- Question