Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PD 5500 - Bevel Degree for Self Reinforced nozzle

Status
Not open for further replies.
hockchong

hockchong

Mechanical
Joined
Dec 9, 2002
Messages
29
Hi everyone,
For ASME Div. 1, normally we will apply 30° for bevel on forge nozzle and 45° for Div. 2.

How about PD 5500? 30° or 45°?

Thanks.

Regards,
Lee
 
Status
Not open for further replies.

Similar threads

ird192
  • Locked
  • Question Question
nozzle to head weld NDE
Replies
6
Views
4K
TomLee777
TomLee777
ROKAA
  • Locked
  • Question Question
Section IX WOPQ, 2G Single Bevel on Pipe
Replies
6
Views
673
ROKAA
ROKAA
Joe2221
  • Locked
  • Question Question
ASME BPVC Full Pen Weld for Nozzle
Replies
3
Views
716
SnTMan
SnTMan
bck2ftr
  • Question Question
ASME B16.9 - factor f for proof test
Replies
3
Views
11K
goutam_freelance
goutam_freelance
YuJie_PV
  • Question Question
factors to be considered for vessels in cyclic service
Replies
11
Views
11K
IdanPV
IdanPV

Part and Inventory Search

Sponsor

Back
Top