Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PCBs

Status
Not open for further replies.

diamondjim

Mechanical
Joined
Jul 30, 2000
Messages
992
Location
US
We have a military base near to me where
they want to burn the buildings that were
painted with high levels of PCBs and they
know that these will turn into dioxins but
the nearest homes are two miles away.
Should I be concerned. They claim this is
a test and want to burn the other buildings
at the arsenal.
 
Diamondjim:

I would think the state and federal environmental authorities would havea great deal to say about this, none of which might be to the liking of base personnel!

Out of curiosity, which arsenal are you referring to?

Orenda
 
Ravenna Arsenal in Ravenna Ohio.
 
Are you sure they were painted with PCBs?

PCBs were probably too expensive to be used in paint for base housing.

TTFN
 
That is what they tell us. It evidently
was typical at the time and someone had
a heavy brush. Because there are residual
explosives in the building they also must
have a high temperature burn. They have
lost lives at other sites when trying
to diassemble similar buildings thus the
reason to try another method. They want
to monitor this as a test site.
 
I don't know what the environmental laws are like where you are, but out here on the West coast, who ever made a serious proposal like that, would be drawn and quartered in the public square. Getting a permit to burn a building for the fire department to practice on is hard enough, but a known haz-mat site, I don't think so. Are these rumors around town, or are these statements that have been published in the local paper?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top