Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PC Card Design

Status
Not open for further replies.

Iqbal

Computer
Aug 27, 1999
8
CA
I am attempting to interface a PC(AT) card to a bus using a motorola 68hc16z microcontroller. The PCMCIA PC card AT specifications require that we have a delay between asserting the card select and putting the address on the bus.(address setup time) secondly, there is a 20nS time delay required between deasserting the card select and readind the pc card. The motorol micro does not have these buitl in delays between the chip selects and the read write pins.
 
Replies continue below

Recommended for you

I'm not sure if I completely understand your question/problem, but you might try putting in some NOP's between the chip select and read/write operation (you'll have to determine how many based on your clock frequency) to create the necessary delay. 20 ns is the MINIMUM delay required. You can make it longer if necessary. I hope this helps a little...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top