Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PAUT TEST

H

Hoseinazadfar

Petroleum
Joined
May 30, 2025
Messages
8
Hi everyone, the pressure vessel body is about 300mm, welded with a narrow gap joint design. Can one-third, then two-thirds, and finally all welds be PAUT or UT tested?
 

Attachments

  • 20250603_165350.jpg
    20250603_165350.jpg
    1.1 MB · Views: 12
  • 20250603_165417.jpg
    20250603_165417.jpg
    929.3 KB · Views: 11
Sort by date Sort by votes
Why not use a measuring tape to take a photo?
What is your role in this project? It looks like you're a student or a visitor.
Do you think the manufacturer doesn't know how to inspect this weld?
 
Upvote -1 Downvote
In addition, our welding engineer advises as follows:

1749221188000.png
 
Upvote 1 Downvote
You must log in or register to reply here.

Similar threads

seagal3232
  • Locked
  • Question Question
Pressure test passed but vacuum test failed
Replies
8
Views
1K
r6155
r6155
zayed78
  • Locked
  • Question Question
Fired Crude Heater - Hydrostatic Test
Replies
5
Views
762
Krausen
Krausen
oldisgold981
  • Locked
  • Question Question
impact test direction
Replies
5
Views
600
r6155
r6155
Delgizjd
  • Locked
  • Question Question
ASME B16.5 #1500 flange maximum test pressure
Replies
6
Views
1K
XL83NL
XL83NL
miramachine
  • Locked
  • Question Question
PSV inlet test requirements
Replies
5
Views
469
IdanPV
IdanPV

Part and Inventory Search

Sponsor

Back
Top