Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pattern Volume Regions?

  • Thread starter Thread starter CaptnPea
  • Start date Start date
Status
Not open for further replies.
C

CaptnPea

Guest
Can you pattern Volume Regions?


Situation:


Volume regions have been added to a hole through a section material that will be used to simulate a fastener being attached. I intend to use beams for the fastener and attach them to the inside of the hole, lots of holes to attach, so this screams pattern table so I don
 
Unfortunately not. Not only pattern but copy and mirroring features are not there.


Israr
 
Status
Not open for further replies.

Similar threads

jeffatmines
  • Locked
  • Question Question
Using desired volume to drive cut-extrude depth dimension
Replies
1
Views
906
jeffatmines
jeffatmines
gpommer1
  • Locked
  • Question Question
Creating a pattern of a surface or volume region
Replies
0
Views
191
gpommer1
gpommer1
nmarco
  • Locked
  • Question Question
Pattern tables and feature name creation
Replies
1
Views
282
mjcole
mjcole
ozzkoz
  • Locked
  • Question Question
volume regions and elastoplatic analysis
Replies
10
Views
382
ozzkoz
ozzkoz
S
volume analysis
Replies
6
Views
6K
SRINIVASANIYER1
S

Part and Inventory Search

Sponsor

Back
Top