Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Patch plate load per para 207-3.5 of ASME PCC 2 -2018

Status
Not open for further replies.
Muhammad Ijaz

Muhammad Ijaz

Mechanical
Joined
Apr 8, 2005
Messages
30
Location
PK
Dear Sir,

Para 207-3.5 of ASME PCC 2-2018 states that "Plug/slot welds may be designed to take up to 30% of the patch plate load.".

Pages_from_ASME_PCC-2_2018_vpm0iu.jpg

Please explain how "Patch plate load" shall be calculated as i could not find the formula to determine patch plate load in ASME PCC 2.

Regards,
Ijaz
 
Status
Not open for further replies.

Similar threads

K.P.M.
  • Question Question
Manufacturer Design report // ASME Sec VIII Div 2
Replies
1
Views
5K
TGS4
TGS4
YuJie_PV
  • Locked
  • Question Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
7K
YuJie_PV
YuJie_PV
YuJie_PV
  • Question Question
some questions regarding the buckling analysis(5.4 of ASME VIII-2)
Replies
3
Views
10K
TGS4
TGS4
victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
15K
victor6397
victor6397
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee

Part and Inventory Search

Sponsor

Back
Top