Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Passing from ANTYPE,STATIC, to ANTYPE,TRANS

Status
Not open for further replies.

Maffo18

Chemical
Joined
Mar 24, 2009
Messages
2
Hello to everyone,
I have a big problem due to an analysis didived into 2 different steps.
In the first one, I performed a static analysis on a component, setting a constrained displacement that bring a surface of component in contact with another surface of a second component.
In the second one I should perform a Transient Analysis in order to study the thermal flux in these two surfaces. But with the change of ANTYPE, Ansys lost any information about the contact and while the analysis is performing, the first component compenetrates the second one. My question is: it is possible to perform this type of analysis? And how can I proceed?
Thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top