PARTS LIST ENHANCEMENT - NX 9?

[topgun101]

Hi John.
I am wondering if the parts list and drawing callout functionality is going to be enhanced when SiemensPLM
overhaul the drafting application? We use Teamcenter
and aloth we can get absolute occurences displaying
in out BOMs, we can't get the find numbers to propergate
through into NX.

Thanks
TonyC

 

[JohnRBaker]

There's a lot of work going on between now and NX 9.0, however it's way too early to say what the specific enhancements will be in any one area. Check back in a few months.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[cowski]

The best way to voice your opinion on what needs to change is to call GTAC and have them open an Enhancement Request (ER). Be ready to clearly describe what you think needs to be improved. Your ER will be added to the list, if enough 'votes' are cast for a specific feature, the developers will give it higher priority for future development.

 

[Arkance/PhoeNX]

@topgun101

let me know what you want Tony and I can log the ER for you

Anthony Galante
Technical Resource Coordinator

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, NX8.0.0.25