Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Part name below Material in NX7.5 Part List
- Thread starter PSI-CAD
- Start date
It would be better to separate the material and part names into individual columns.
www.nxjournaling.com
www.nxjournaling.com
- Thread starter
- #3
Hi Cowski,
It's a special demand from one Customer to reduce the width for a Vertical A4 Sheet. I don't want to use Edit Text in each cellule like I have done in the header
Regards
Didier Psaltopoulos
It's a special demand from one Customer to reduce the width for a Vertical A4 Sheet. I don't want to use Edit Text in each cellule like I have done in the header
Regards
Didier Psaltopoulos
JohnRBaker
Mechanical
I don't think that there is any way to force the system to display two lines of text in a single cell of the Parts List with any degree of control as to what gets displayed on which line. The only thing that might work would be to set-up the 'Fit Methods' for the cell of interest to use the 'Wrap' option and then add as many spaces between the Part name and the Material as needed so that it would force them to 'wrap' and therefore appear as two lines of text.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #5
- Status
Similar threads
- Question
