Good day. I am having an issue getting a BOM to export the material properties of parts in an assembly to excel. I am not very experienced with VB hence wanting to use a advanced BOM. I would like to get CG co ordinates and a mass of parts into excel from assemblies. Any suggestion on the way forward?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Part mass and CG 1
- Thread starter nicsachal
- Start date
-
1
- #2
- Thread starter
- #3
There are a lot of posts about BoM, did you search through them? https://www.eng-tips.com/search/8722974/?q=BoM&t=post&c[child_nodes]=1&c[nodes][0]=560&o=date
- Thread starter
- #5
Similar threads
- Question
- Locked
- Question