Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Part list and palettes

Thread starter ug2prog
Start date Nov 2, 2005

Status: Not open for further replies.

Nov 2, 2005

ug2prog

Mechanical

I need to create a autobom in drafting. I have the assembly with partfamily files and stock, which is created with all the required attributes. Also I have the .pax file. I have the template of the part list table. But I stuck with creating the autobom with my table. I linked the .pax file in the palettes, I am not sure after this..
Thanks if some one post a right way to create this..