Part family item description updating in NX-TCE

[ashivu123]

I created part families for a Bolt in NX-6 integrated with Teamcenter, now I would like to add description for each family member like .190-32unf-3A_.625GRIP_1.032L based on the thread type and bolt length.
I added DB_PART_DESC from Attributes (Pull-down) and entered the description for each part in spread sheet. Updated each family members and status shows successfully updated. However when I check Item description in Teamcenter for each family members I does not updated.
Suggest me on this issue.

 

[JurgenKreisel]

I do not believe that you can change any attributes that start with DB_ once the items have been created via the spread sheet. I once had to do something like that and ended up deleting the items in TC and then recreating them via the spread sheet. I know that at-least now in UG9 you can change the order of the columns in the spread sheet.

Someone else may have other suggestions but this was my experience.

Jurgen
NX8, NX9 TC8.3 TC10.1