PART DISPLAY PROBLEM IN NX8

[BABUGOUDA]

Hi,
I am facing a display problem with the parts in NX. so the parts appear like as if they are scattered.it makes very odd when i am in design meeting
Please find the image. and tell me any settings ??
thanks in advance

I am using Nx8

Thx
Pat.

 

[kapmnit123]

Hi Pat,
Try putting of the option Highlight Original (Preferences/Selection/Highlight Original). Sorry i don't have NX8 installed with me and i have a little doubt when was this option brought inside NX (NX8 or NX8.5).But still worth giving a try.
Best Regards
Kapil Sharma

 

[Toost]

Have you run earlier NX versions on this computer successfully ?
It , to me , looks like a graphics driver / graphics adapter problem.
Is the computer on the Siemens Certified list ?
does it have a certified graphics card ? - The certified driver ?
see:

http://support.industrysoftware.aut...ertification/Graphics_Certification_Table.xls

Regards,
Tomas