Parameters for Basic Curves - NX10

[randy64]

In NX9 and previous revisions, I could put a circle in using basic curves and was able to make it a certain size, e.g. diameter .50". Now, in NX10, I cannot find a way to do this. Has that functionality been deleted, or did they just hide it and I can't find it?

Thanks

 

[cowski]

The tracking bar lets you enter a radius or diameter for a basic curve circle. If the tracking bar does not appear when you start the basic curves command, see this thread for how to get it back.

thread561-405429

www.nxjournaling.com