Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
PAPER SPACE VIEW?
- Thread starter jkelly
- Start date
Dear jkelly,
You should create a viewport in paper space and activate the model in the viewport. Then enter the VP command and set the view angles for the front view in the dialog box as follow:
X Axis=31° and XY Plane=0°
or for the side view:
X Axis=121° and XY Plane=0°
If you need to set view on top as a rectangle, You should set the ucs (3P option in UCS command) on top of the part so that X and Y axes lie on the part edges and then enter the VP command. In dialog box select the option "Relative to UCS", click on "Set to view plan" button and at last click on "OK".
Farzad
You should create a viewport in paper space and activate the model in the viewport. Then enter the VP command and set the view angles for the front view in the dialog box as follow:
X Axis=31° and XY Plane=0°
or for the side view:
X Axis=121° and XY Plane=0°
If you need to set view on top as a rectangle, You should set the ucs (3P option in UCS command) on top of the part so that X and Y axes lie on the part edges and then enter the VP command. In dialog box select the option "Relative to UCS", click on "Set to view plan" button and at last click on "OK".
Farzad
- Status
Similar threads
