mohsanj
Electrical
- Oct 22, 2015
- 1
am working in a mineral water company and recently facing problem with an ozone generator ozocan psx 12 model
a week ago the condition was when we connect ozone output line of ozone gen to out tank, pressure builts in line and automatically ozone gen drops its efficiency to 25 percent
but a week after its not going up from 10 percent even if i open that output line
i have checked everything in my knowledge
a)inverter input and out voltage
b)inverter output frequency
c)cosulted the drawing if there is any analog signal to control it auto but there is nothing
if there is anyyyyyyyything in this mater please help
a week ago the condition was when we connect ozone output line of ozone gen to out tank, pressure builts in line and automatically ozone gen drops its efficiency to 25 percent
but a week after its not going up from 10 percent even if i open that output line
i have checked everything in my knowledge
a)inverter input and out voltage
b)inverter output frequency
c)cosulted the drawing if there is any analog signal to control it auto but there is nothing
if there is anyyyyyyyything in this mater please help