Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Overriding Dimension leaders

Status
Not open for further replies.

pkpavv

Mechanical
Joined
Jul 5, 2007
Messages
37
Location
US
Dear All,

I am trying to show angles of an Isometric view on drawing sheet. SW not allowing me to show included angle the way I want, instead it is showing out side angle in the way it likes.

Though, I dont want to show the exact measured angle, I want to show some angle like dimension on my drawing sheet so that I can ovdrride the value I like. Is there a way in SW to show manual leaders for angle measurement??

I have been trying very hard on this from my end but without break thru.It would be great help, if somebody could guide me right way of approach.

Please find attached zip file, which inclues my test model/drawing and pdf of drawing for those who have older version than SW-2007


Regards,
Pa1
 
Click your Dimension Button, Alt, Shift, then pick your 2 lines.
Sylvia
 
Hi CBL/ctopher,

Your idea perfectly worked for me! Thanks very much.

Regards,
Pa1

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top