Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Output contact pressures in ANSYS Mechanical

Status
Not open for further replies.
lateralan89

lateralan89

Mechanical
Joined
May 31, 2013
Messages
1
Location
US
I would like to output the contact pressures between two surfaces in an axisymmetric model. The contact tool only gives min and max where I would like to have all the results. I have tried some macros I found online with no success. Ansys doesn't seem to be able to retrieve the CONTPRES data. Does anyone know how to do this? I would like to output all nodes at all load steps.

Thanks
 
Status
Not open for further replies.

Similar threads

X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
M
  • Locked
  • Question Question
ANSYS Mechanical Scripting: how to delete an existing heatflux?
Replies
0
Views
869
MihailW
M
TeoAlfa
  • Locked
  • Question Question
ANSYS Mechanical - Concrete embedded steel components
Replies
0
Views
753
TeoAlfa
TeoAlfa
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner

Part and Inventory Search

Sponsor

Back
Top