Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Out-of-round tube holes

Status
Not open for further replies.
jdvmre

jdvmre

Mechanical
Oct 5, 2011
1
We are currently repairing a mud drum with out-of-round tube holes (see attached picture) and we want to correct it by weld build-up. The holes were chipped/damaged during cutting. What ASME code supports this procedure?
 
Status
Not open for further replies.

Similar threads

S
  • Question
Tapped axial holes on tube
2 3
Replies
55
Views
4K
Stress_Eng
Stress_Eng
M
  • Question
ANSYS - Tube Bending and Measured Ovality
Replies
6
Views
3K
MECHENGTOM
M
M
  • Locked
  • Question
Force Required to Crush a Tube
Replies
16
Views
6K
Stress_Eng
Stress_Eng
franhd
  • Locked
  • Question
Standards on filling holes with weld
Replies
8
Views
989
mfgenggear
mfgenggear
H
  • Question
Reference Dimensioning for coiled tube weldments in circular block with coiled groves?
Replies
0
Views
1K
Himalaya Nath
H

Part and Inventory Search

Sponsor

Back
Top Bottom