Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Orifice Flow Conditions

Status
Not open for further replies.

MatthewD

Chemical
Joined
Nov 17, 2004
Messages
35
Location
CA
I am curently designing a orifice plate that is attached to the discharge of a pressurized vessel. Since this is a transient system I am not sure at what point during the depressurization I should use for the designing of the orifice. Any advice would be appreciated.
 
Jay165 I find the idea of a choke nipple appealing. I wish I could provide a flowsheet but I have to be careful about confidentiality btw my company and our clients. Everyone has been very helpful and my thanks to everyone in this regard
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top