Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Orient WCS default
- Thread starter eric1266
- Start date
There is no way to change this default that I know of. Most dialogs 'remember' the option you chose last time, this is one of those which don't.
Other dialogs that I hope change are:
studio spline: drawing plane defaults to view plane rather than your last choice.
face analysis vector dialog defaults to 2-point (inferred would be a much better default if it won't remember the last choice).
The extrude dialog has a mix of 'remembered' options and defaults which can be annoying at times.
I'm sure there are others that need improvement.
Other dialogs that I hope change are:
studio spline: drawing plane defaults to view plane rather than your last choice.
face analysis vector dialog defaults to 2-point (inferred would be a much better default if it won't remember the last choice).
The extrude dialog has a mix of 'remembered' options and defaults which can be annoying at times.
I'm sure there are others that need improvement.
- Thread starter
- #3
- Thread starter
- #5
No you're right. If I wanted to use dynamic I'd use the other icon that is specifically for Dynamic WCS manipulation! The sooner this is changed back or as Cowski say made sticky the better off we'll all be!
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
- Thread starter
- #7
- Status
Similar threads
