Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ordinary Cantilever Column - SDC D, E & F 1

Status
Not open for further replies.

Shanman_

Structural
Oct 25, 2017
18
In your opinion, may I use an OCCS in SDC D, E OR F using referenced footnote "i" of table 12.2-1 of the ASCE 7-10?

That footnote is specifically labelled as an exception for OMFs in its own section but is explicitly referenced as a footnote for OCCS in the aforementioned table.

Thanks.
 
Replies continue below

Recommended for you

Looks like it - can't see in any errata suggesting that the "i" footnotes are misplaced.

Check out Eng-Tips Forum's Policies here:
faq731-376
 
The same note is in ASCE 7-16 but it is now footnote "L". So looks like it's not a misprint.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor