Orcad and SW

[macduff]

Hi All,
Is there any way to transfer SW templates to Orcad? I tried dxf and dwg but Orcad can't read those extensions.

Thanks a bunch,

macduff

Macduff
Meggitt Airdynamics Inc.

 

[SBaugh]

Those are your only choices for exporting your SW Template. Unless you see something in the "Save as type" box. If not... then your SOL.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376

 

[ctopher]

I have sent DXF from SolidWorks to OrCad. You need to import it. If you still can't do it, try upgrading. I am not sure of the settings, it is another user that I sent it to using OrCad.