Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Operational Ampifier

Status
Not open for further replies.
iconchris

iconchris

Chemical
Joined
Aug 8, 2003
Messages
7
Location
US
I am trying to dive a proportional control valve from a PLC. The analog output from my PLC is a (low power) 0-10 Volts signal. The valve requires a 0-15 VDC (150 mA) signal. I know I can build a relatively cheap an easy Op Amp to accomplish this. I would prefer to get an off the shelf Din Rail Mount Unit that could handle multiple channels. Does anyone have any thoughts on this?

Thanks for the help.
 
Sort by date Sort by votes
check Phoenix Contact for
amplifier modules.
rodar
 
Upvote 0 Downvote
pls i will like to know more on this topic
 
Upvote 0 Downvote
You may get a better response if you post this question in the Programmable Logic Controllers (PLC) Forum.
 
Upvote 0 Downvote
I have decided to have a supplier manufacture a PCB with multiple channels. It seems like the easiest and cheapest route to take.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top