Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
OFFSET line becomes MLINE
- Thread starter bigalex
- Start date
Hey,
when this happens ... do you mean the 2 lines become ... "grouped"?
Is so, it sounds like an "associative" variable is set on.
Don't know which one but ... I have seen this once or twice.
My solution was to make sure all the "template" files used to create new CAD files were clean and no funky variables were set.
As for the funky file, I just (three times) "burst" everything displayed and then "wblock" the line work out. And "insert" that into a clean file.
A little extreme but I haven't seen this problem ever again.
We've upgraded to AutoCAD 2002 since then .....
Later guy
![[spin]](/data/assets/smilies/spin.gif "[spin] [spin]")
when this happens ... do you mean the 2 lines become ... "grouped"?
Is so, it sounds like an "associative" variable is set on.
Don't know which one but ... I have seen this once or twice.
My solution was to make sure all the "template" files used to create new CAD files were clean and no funky variables were set.
As for the funky file, I just (three times) "burst" everything displayed and then "wblock" the line work out. And "insert" that into a clean file.
A little extreme but I haven't seen this problem ever again.
We've upgraded to AutoCAD 2002 since then .....
Later guy
- Status