Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
offset curves
- Thread starter mackinklr
- Start date
Don't get mad on Pro/E until you're sure you should.
To create an offset curve go to Create --> Datum curve --> Offset curve.....and follow all those steps.
Even easier, you don't need to offset your curve. Instead you can create your protrusion by offseting the curve in sketch mode:
Create --> Protrusion --> And use "Offset edge" in sketch mode for your thickness
Good luck!![[pipe]](/data/assets/smilies/pipe.gif "[pipe] [pipe]")
im4cad
Pro Design Services, Inc.
To create an offset curve go to Create --> Datum curve --> Offset curve.....and follow all those steps.
Even easier, you don't need to offset your curve. Instead you can create your protrusion by offseting the curve in sketch mode:
Create --> Protrusion --> And use "Offset edge" in sketch mode for your thickness
Good luck!
im4cadPro Design Services, Inc.
- Status
Similar threads
- Locked
- Question
- Locked
- Question