Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

offset a single curve in a sketch

Status
Not open for further replies.
lgnx

lgnx

Mechanical
Joined
Nov 4, 2018
Messages
52
Location
DE
Hi

a sketch consists chain of curves making a closed profile, i want to offset only one curve. but offset option chooses full closed profile. how to do this NX?
 
Sort by date Sort by votes
Did sou set the selection option to single curve?

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11
 
Upvote 0 Downvote
NutAce,

where is that option? i couldnt find. see below image.


1_s9j8v5.png
 
Upvote 0 Downvote
NutAce,

thanks. i got it.
1_jlgcgi.png
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

E
  • Question Question
Direction of an Offset Curve
Replies
0
Views
1K
ErkiPerki
E
Nahid Mubin
  • Question Question
Exploded view from several assemblies to a single drawing file
Replies
2
Views
7K
cowski
cowski
Jashe
  • Question Question
Sketch Failure Message in NX
Replies
3
Views
2K
Jashe
Jashe
E
  • Question Question
Offset Surface looks crumpled
Replies
2
Views
3K
Emer4ld
E
CAD2015
  • Question Question
Convert components from an assembly into one single part.......
Replies
5
Views
7K
CAD2015
CAD2015

Part and Inventory Search

Sponsor

Back
Top