Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Obtaining BOM information

Status
Not open for further replies.

PrashantSL

Computer
Joined
Dec 11, 2008
Messages
2
Hi,

I asked question about the BOMTable:Attach3 and I found out the solution to it.
If I use Excel based BOM table then through VIEW I am able to attach and get the row by row contents of the table.

But I have another question here.
I am getting only name of the part/assembly that is there in drawing. But I am not able to know the type and filename by using name obtained from BOM.
How can I get information about TYPE/Filename associated with each row in BOM.

Also if I have same name for Assembly and part then how can I distinguish whether it is part or assembly merely by looking at name.

Any help of clue will be much appreciated!
If I am wrong at phrasing the question do tell as I am very new to all these things....

Thanks.
Prashant
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top