Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

OBTAIN SAME SURFACE COLOR IN DRAFTING 5

Status
Not open for further replies.

ingenieromx

Mechanical
Joined
Apr 21, 2010
Messages
7
Location
MX
HI, I USE CATIA V5R18 AND WHEN I MAKE MY DRAWINGS FROM 3D PARTS I WANT THE SAME COLOR IN SOME VIEWS (FOR ISOMETRICS VIEWS) TO LOOK LIKE MORE PROFESSIONAL, BUT JUST THE LINES CHANGE COLOR AND NOT THE FACES OF THE PART.
IS IT POSSIBLE??
I PREVIOUSLY USED AUTODESK INVENTOR 2010 IN OTHER JOB AND I COULD DO THAT, I ASSUME CATIA CAN DO IT TOO, OR NOT??

 
You can use Fill Area, change hatch in pattern type with coloring.

Regards
Fernando
 
Just change the view to raster, shaded, ensure use 3d colours is checked and press Caps Lock once
 
Great Peter, I didn't know about that, star from me.

Regards
Fernando
 
THAT WAS VERY HELPFUL, THANK YOU PETERGUY!!!
 
It took me a while to understand the "caps lock" thingy, but now I just can't stop laughing... :DDDD

All in all, nice tip, thanks !
 
"..press caps lock once" ..........hilarious
 
one star for the caps lock...

Eric N.
indocti discant et ament meminisse periti
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top