Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NXDisplayParent tool

Status
Not open for further replies.
cubalibre000

cubalibre000

Mechanical
Joined
Jan 27, 2006
Messages
1,070
Location
IT
Hi,
it's possible to have the source code of tool presented in the thread561-351100 ?
It's useful, but I'd like to add attribute on the left of the code and increase the speed to show results.
Thank you,

Thank you...

Using NX 8 and PDM RuleDesigner
 
Status
Not open for further replies.

Similar threads

Kenja824
  • Question Question
NX2406 - Flatten and Forming Tool Not Projecting all the points
Replies
1
Views
6K
Carbonated
Carbonated
K
  • Locked
  • Question Question
Sew: tool does not share a common boundary
Replies
3
Views
2K
cowski
cowski
Dbfoster24
  • Locked
  • Question Question
Shop Doc Variable for OVL of Tool Assembly? Also Tool Image?
Replies
0
Views
416
Dbfoster24
Dbfoster24
gluten02
  • Locked
  • Question Question
Can't figure out deform tool
Replies
1
Views
398
Toost
Toost
Atharva_Mechanical
  • Locked
  • Question Question
NX unite command issue - tool and target do not form complete intersection
Replies
3
Views
1K
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top