NX9 manufacturing operation dialog 1

[bongoman]

In NX9.0.3.4 MP1 manufacturing, operation navigator, program order. In the operation dialog box - "Feeds and Speeds". I cannot get the Feed Rates part of the dialog to stay open even after opening it and OK and OK the main operation dialog. When I go back in to the operation dialog the Feed Rates portion is closed again. Does anyone know how to change this behavior so it stays open when you return to the "Feeds and Speeds" dialog.

Any help would be greatly appreciated.

Thanks,
Rick D.


Win7 64 bit w/NX7.5 and NX9.0.2.5
Vericut 7.3

 

[markrief]

Try clearing the dialog memory. If this still happens, please report it to GTAC. The open/closed state of each collapsible group should be remembered.

Mark Rief
NX CAM Customer Success
Siemens PLM Software

 

[Arkance/PhoeNX]

Have you got a picture/s to explain what you mean?

Anthony Galante
Senior Support Engineer

NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.3, NX10 Beta

 

[bongoman]

Thanks Mark,

Clearing the dialog memory was the ticket. I had originally tried that but there was 2 versions of NX9 running at the same time so
both had to be shut down before the change would take affect.

Rick D.

Win7 64 bit w/NX7.5 and NX9.0.3.4 MP1
Vericut 7.3